Richmat HJH159 Ble Remote Control
Remote control button map
System configuration diagram
Remote control function description
| Button label | Function |
| 1 | 1 Under-bed light on/off (5 minutes off) |
2 | Short press and release to run to TV position (with initial value). Multiplexing function: FLAT+TV, the backlight flashes, the buzzer sounds, and the current motor position is recorded to the TV position. (Power-off clear). |
3 | Short press and release to run to SNORE position (with initial value). Multiplexing function: FLAT+SNORE, the backlight flashes, the buzzer sounds, and the current motor position is recorded to the SNORE position. (Power-off clear). |
4 | Short press and release to run to ZG position (with initial value). Multiplexing function: FLAT+ZG, the backlight flashes, the buzzer sounds, and the current motor position is recorded to the ZG position. (Power-off clear). |
| 5 | Back up, release to stop |
| 6 | Feet rise, release to stop |
| 7 | Back down, release to stop |
| 8 | Feet down, release to stop |
| 9 | One-key reset, all motors reset to the end, power-on reset. |
| 10 | External drag two rise, release stop (TILT) |
| 11 | External tow two descend, release stop (TILT) |
| 12 | Pull it up and release it to stop (LUMBAR) |
| 13 | Pull down and release to stop (LUMBAR) |
14 | The head massager is enhanced, the massager can be turned on (automatically turn off after 30 minutes) (1→2→3 →4→5→6→7→off cycle switching) |
15 | The foot massager is enhanced, the massager can be turned on (automatically turn off after 30 minutes) (1→2→3 →4→5→6→7→off cycle switching) |
| 16 | Light up the flashlight |
17 | Adjust the massage motor mode, after the massager has been turned on, press this button, and the massage motor that has been working will enter the “PULSE” mode, after pressing the button again, the massage motor will enter the “WAVE” mode, after pressing the button again, the massage motor |
| will enter the “PULSE” mode. Enter the “CONSTANT” mode, after pressing the button again, the massage motor enters the “PULSE” mode and cycle in turn. | |
18 | Massager off. The working time of the massager is set at 10min, 20min and 30min respectively, and the timing time is displayed by the indicator light. Reserved function The motor runs to the M1 position with one key (no initial value) (not clear when power off) |
| Pairing method: [Remote control back up + foot up (5,6) + control box pairing key] The buzzer sounds, indicating that the pairing is successful. * The code key of the control box has a reset function * The control box is powered on and reset, and the reset process cannot be interrupted by any key. | |
| Remote control mutual learning function (A: to learn the remote control, B: to learn the remote control): 1. B learns A: long press B’s back down + foot down (7, 8) for 5s, the flashlight is on, you need to press back up + foot up (5, 6) within 10 seconds, B’s flashlight flashes, indicating learning success. 2. To cancel the learning function: long press B’s back up + foot down (5, 8) for 5s, the flashlight is on, indicating that the cancellation is successful. | |
Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions
- (1) This device may not cause harmful interference
- (2) This device must accept any interference received, including interference that may cause undesired operation.
- Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
For more manuals by Richmat, visit ManualsLibraryy
Richmat HJH159 Ble Remote Control-FAQs
What is the Richmat HJH159 BLE Remote used for?
The HJH159 BLE Remote is designed for controlling smart home devices like adjustable beds. It provides wireless functionality via Bluetooth.
How do I pair the Richmat HJH159 Remote with my device?
To pair, press and hold specific buttons on the remote while activating the pairing mode on the device (refer to the user manual for exact steps).
Does the HJH159 Remote work with non-Richmat devices?
It is optimized for Richmat products. Compatibility with other brands depends on the Bluetooth protocol.
Can the Richmat HJH159 Remote control multiple devices?
Yes, if supported by your devices. You may need to switch between devices via the remote or app.
What are the power requirements for the HJH159 BLE Remote?
It typically uses standard AAA batteries or rechargeable cells (check your manual for specifics).
What is the Bluetooth range of the HJH159 Remote?
The range is typically 10–30 meters, depending on environmental factors like walls and interference.
Is there an app to enhance functionality?
Yes, some Richmat remotes are compatible with companion apps for additional customization.
How do I reset the HJH159 BLE Remote?
Press and hold a reset button (if available) or remove and reinsert the batteries to reset.
What should I do if the remote stops working?
Check the batteries, ensure proper Bluetooth pairing, and verify that the controlled device is powered on.
Where can I get a replacement manual for the Richmat HJH159 Remote?
Replacement manuals can often be found online on Richmat’s official site or FCC documentation, such as this source